Select your vehicle

Banks Power Water-Methanol Injection Fitting – 45120

Banks Power

Shop on Amazon

Compare current versions and compatible options on Amazon, then check out with your Amazon account.

Slickrock 4X4 is a participant in the Amazon Associates Program. As an Amazon Associate we earn from qualifying purchases.

  • Methanol injection kit fitting from Banks Power
  • Part number GBE45120
  • Used to install or customize a methanol injection kit
  • Universal fit for methanol injection kits

Description

Overview

The Banks Power water-methanol injection fitting, part number GBE45120, is used to install or customize a methanol injection kit. It is a universal fit fitting, so it is not tied to any particular vehicle.

Because the item is a kit fitting rather than a vehicle-specific part, match it to your methanol injection kit before installing it.

Key features

  • Used to install a methanol injection kit
  • Also used to customize a methanol injection kit
  • Universal fit
  • Banks Power part number GBE45120

Tuning a methanol setup

Water-methanol injection cools the intake charge, which helps an engine resist knock when it is working hard or towing. The fitting is one link in that system, so a leak at this point affects the whole setup. Heat and vibration are the usual reasons these joints loosen over time. Route the line away from heat sources and moving parts, and keep it clear of sharp edges that could wear through the tubing.

Fluid quality and tank care matter as much as the hardware. Use the fluid type your kit calls for, keep the reservoir clean, and check the inlet screen or filter if one is fitted. Inspect the connection after the first few drives and again at routine service intervals, looking for seepage, residue or loose clamps. Residue around a fitting often shows up before a leak becomes obvious.

  • Inspect lines for cracks or hardening
  • Look for residue around fittings
  • Recheck clamps after the first drives

Specifications

Brand Banks Power
Part number GBE45120
Product type Methanol injection fitting
Fitment Universal fit

Vehicle fitment

The fitting is universal fit, tied to your methanol injection kit rather than to a make, model or year. Confirm your vehicle’s year, model and trim before ordering.

Confirm your vehicle’s year, model and trim before ordering.

Installation notes

Check the fitting against your methanol injection kit before installing it. Match thread and line sizes to your kit’s fittings before connecting.

What’s included

The package is a fitting only, with no other parts included. Check the package contents against your installation before starting.

Questions & Answers

What is Banks Power part GBE45120?

It is a water-methanol injection fitting from Banks Power, used to install or customize a methanol injection kit. Its part number is GBE45120, and it is a universal fit part with no vehicle tied to it.

Does this fitting work with any vehicle?

No vehicle is tied to this fitting, since it is universal fit and is not limited to a make, model or year. Whether it suits your setup depends on the methanol injection kit you own, so confirm compatibility with that kit first.

What thread or line sizes does this fitting use?

Confirm thread, line and port sizes against your methanol injection kit before you install the fitting. Matching those sizes to the kit's connections is the surest way to avoid leaks.

How can I tell if the injection fitting is leaking?

Look for wet residue, a sweet or alcohol smell, or fluid dripping near the connection after a drive. Check the joint with the engine off and tighten any loose clamp before refilling the reservoir. Replace a cracked or damaged line rather than relying on tape or sealant.

Find it on Amazon

Compare current versions and compatible options on Amazon, then check out with your Amazon account.

Shop on Amazon