Overview
Part ASI101005MC201 is a black Assault Industries registration plate measuring 4 by 2.55 inches, with a 1.5 inch clamp for attaching it to a UTV.
It holds a registration sticker or license tag and is made from 6061 T6 aluminum, hard anodized black, with a laser engraved logo. It is designed to mount to the back of most UTVs.
Key features
- 6061 T6 aluminum plate
- Hard anodized black finish
- 1.5 inch clamp
- Laser engraved logo
Choosing a UTV plate mount
A UTV registration plate mount carries the plate over rough ground, so the clamp and the bracket behind it matter as much as the plate itself. Before buying, measure the tube or bar where the clamp will sit and confirm its diameter matches the clamp size. Loose clamps are a common reason a plate rattles or swings sideways after a few rides. Pick a mount that sits clear of the tires, a spare, and any rear rack so the registration stays readable and is less exposed to mud and brush. Mounts that bolt through the frame usually hold steadier than ones held by a single clamp screw.
Aluminum with a hard anodized finish resists scratches from branches and gravel, but the surface can still mark if rubbed against a metal bracket. Clean grit off the plate and bracket before tightening so the finish is not worn at the contact points.
- Tighten clamp bolts after the first few rides
- Check the plate for cracks around the mounting holes
- Keep the sticker visible and unobstructed
- Use anti-theft fasteners if the mount allows them
Specifications
| Brand | Assault Industries |
|---|---|
| Part number | ASI101005MC201 |
| Plate size | 4 x 2.55 inch |
| Clamp size | 1.5 inch |
| Material | 6061 T6 aluminum |
| Finish | Hard anodized black |
| Logo | Laser engraved |
Vehicle fitment
No specific vehicle is named for this plate. Because it attaches with a 1.5 inch clamp, the mount on your UTV has to accept that size.
Confirm the mount takes a 1.5 inch clamp before ordering.











