Overview
The Artec FM0122 is a bare steel fuel cell mount for securing a JAZ Pro Sport 22 gallon fuel cell. It adds strength and a cleaner look than two steel straps. It is made for the fuel cell rather than a vehicle, and the cell’s prefix determines fit.
The mount is made of six steel pieces: two CNC cut, bent and dimpled tops, two side brackets and two bases. The bases are shaped for notching on tube chassis, and they can be left off when the cell sits on a flat surface such as a truck bed.
Key features
- Two CNC cut, bent and dimpled tops from 16 gauge cold roll steel
- Two 10 gauge side brackets and two 10 gauge bases for strength
- Bases shaped for notching on tube chassis
- Bases can be omitted for flat surface mounting, such as a truck bed
- Works with foam and non-foam versions of the cell
- Top bolt holes line up with the cell flange, with room for extra holes
- Six pieces total with 1/4 inch hardware included
Tube chassis and flat mounting
The FM0122 is used in two common setups. On a tube chassis the bases can be notched around the tubing, which lets the cell sit close to the frame. On a flat surface such as a truck bed, the bases can be left off, so the tops and side brackets carry the load on a level floor. Choose the setup before drilling anything.
Either setup depends on a solid mounting point and clear space for fuel lines and fittings. Foam and non-foam cells can be used with this mount, so confirm which version you have before drilling. Keep the cell away from exhaust heat and moving suspension parts, and route lines so they cannot chafe.
- Confirm the cell prefix before drilling
- Route lines away from sharp edges
- Leave room for fittings and vent access
- Recheck fasteners after the first drives
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | FM0122 |
| UPC | 816791020826 |
| Part type | Fuel cell mount |
| Cell compatibility | JAZ Pro Sport and Pro Sport II cells with prefixes 270, 272, 273, 274, 280, 281, 282 or 283 (example 270-122-06) |
| Can size | 22 gallon |
| Fluid type | Gasoline |
| Top material | 16 gauge cold roll steel |
| Side brackets and bases | 10 gauge steel |
| Pieces | 6 |
| Hardware | 1/4 inch included |
| Finish | Bare steel; requires paint, powdercoat or plating |
| Model 122 dimensions | 34.5 L x 18.375 W x 10.5 H |
Vehicle fitment
No vehicle fitment is given. The mount is matched to JAZ Pro Sport and Pro Sport II fuel cells by prefix, so check the cell prefix and mounting setup before fitting it.
The mount is made only for the cell prefixes above. Confirm the cell prefix and mounting setup before ordering.
Installation notes
The mount needs bolt holes drilled in the fuel cell flange, and the drilling must be done carefully. Paint, powdercoat or plate the bare steel before use to prevent rust. Work carefully around a fuel cell, since a fuel leak is a serious hazard.
What’s included
Six steel pieces: two tops, two side brackets and two bases, plus 1/4 inch hardware.
Not included: the fuel cell itself, and the bolt holes in the cell flange must be drilled separately.














