Overview
The ARB Xtras For Axle Breather Kit is a set of tubing and push fittings made for ARB part number 170112. It works as an accessory for an axle breather setup and is not a complete breather on its own.
Key features
- Tubing included
- Push fittings included
- Made for ARB part number 170112
Understanding axle breathers
An axle breather lets pressure equalize inside the axle housing as the temperature changes, which helps keep water and dust out past the seals. Without one, pressure can push lubricant past seals or pull contaminants in. Breather fittings usually run through small-bore tubing, so a clean route with gentle bends keeps the vent from pinching or collecting fluid.
When you install tubing and push fittings, cut the line square, push it fully into the fitting and confirm it locks. Route the tube above the fluid level and away from hot exhaust or moving parts. After the first few drives, check each joint for weeping and re-seat it if needed. Axle vents work best when the housing is kept clean and the vent is not blocked by mud.
Specifications
| Brand | ARB 4×4 Accessories |
|---|---|
| Compatible part number | 170112 |
| UPC | 70000708351 |
| Contents | Tubing and push fittings |
Vehicle fitment
The kit is made for ARB part number 170112. Confirm the vehicle, year and axle that use that part before ordering.
Confirm the axle and vehicle that use part 170112 before choosing this kit.
What’s included
Tubing and push fittings for part number 170112.
Not included: The breather unit these fittings connect to is a separate item, so confirm you have one before installing the kit.









