Overview
The AMP-Research PowerStep in black, part number AMP75132-01A, is an automatic electric running board, also called a power step, for the 2018–2026 Jeep Wrangler (JL) Unlimited four-door models. It extends when a door opens and retracts up toward the body when the doors close.
The step can deploy up to 13 inches down and out, which gives an easier step height for getting in and out. Because it retracts, the vehicle keeps its designed ground clearance, and the top of the step stays cleaner than a static step bar.
Depending on the application, the step may sit out of sight until a door is opened, or sit just outside the lower rocker panel for a clean, smooth look. The design hides spot welds and other underbody parts that do not need to be seen.
The rocker rail design gives a uniform appearance and a three-inch lower berth, which AMP Research says eases maneuvering when stepping in and out. The three-inch drop also adds strength when the steps are withdrawn.
Key features
- Automatic electric operation that extends when a door opens and retracts when the doors close
- Deploys up to 13 inches down and out for an easier step height
- Retracts to keep the vehicle’s designed ground clearance
- Rocker rail design with a three-inch lower berth
- Hides spot welds and underbody parts when stowed, for a clean rocker panel look
- Black finish with wheel-to-wheel length
Electric running board upkeep
An electric running board has a motor, gearing and a set of moving parts that work best when kept clear of grit and water. After off-road use or deep water, rinse the step and wipe down the rails and visible joints. Dried mud can stiffen the mechanism and slow the extension, so cleaning helps keep the step operating smoothly.
Check the step while it cycles. Listen for unusual grinding, watch for uneven extension, and make sure it returns fully when the doors close. If the step stops partway, check the battery and connections before assuming a mechanical fault, since a weak electrical supply can cause the same symptom.
Periodically inspect the mounting hardware and the wiring routing. Loose fasteners can let the step rattle or shift, and a pinched cable can cause intermittent operation. Keep the cables secured away from heat sources and moving parts.
Specifications
| Brand | AMP-Research |
|---|---|
| Part number | AMP75132-01A |
| Finish | Black |
| Length | Wheel to wheel |
| Deployment | Up to 13 inches down and out |
| Lower berth | Three inches (rocker rail design) |
| Operation | Automatic, electric-powered |
| Warranty | 5-year/60,000-mile |
| Fitment type | Direct fit |
Vehicle fitment
The manufacturer fitment list covers 2018–2026 Jeep Wrangler (JL) Unlimited four-door models, including the 80th Anniversary, Freedom, High Altitude, High Altitude 4xe, Islander, Moab, Rubicon, Rubicon 392, Rubicon 4xe, Sahara, Sahara 4xe, Sahara Altitude, Sport, Sport Altitude, Sport S, Willys and Willys Sport trims.
Two-door Wrangler JL models and earlier Wrangler generations are not on this list.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This is an electric step, so the power and control wiring must be connected carefully. Disconnect the battery before working on any wiring.
What’s included
Verify the package contents before installing the step.











