Overview
The Tuffy 142-01 is an overhead security console with one lockable compartment for mounting a stereo, CB radio, speaker or other electronic device. It is made from 16-gauge steel with a black powder coat finish, bolts in securely without drilling, and works with a factory hardtop or soft top on 2-door and 4-door models.
The compartment door swings up flush and latches open, and it is secured by a double bitted 10 tumbler lock with built-in weather seals. The sliding design leaves the levers for removing the factory tops accessible.
Key features
- One lockable compartment
- 16-gauge steel design with a black powder coat finish
- Requires no drilling and bolts in securely
- Works with a factory hardtop or soft top
- 2-door and 4-door models
- Single lock operation with a high security 10 tumbler double bitted key
- Pre-punched hole for a CB mic
- Door swings up flush and latches open
- 4 speaker grille cutout holds a 5 1/4 speaker
- Bolt-in bracket for a DIN mount stereo or CB radio
Mounting a console safely
A console like this is usually used to store a stereo, CB radio or small electronics within easy reach of the front seats. Before mounting any electronics, disconnect the battery, plan the wiring route away from moving parts and sharp edges, and use fuses on each power line. A loose wire near a steering column or pedal can cause real trouble, so route it cleanly.
The lock and the swing-away door need occasional care. Keep the lock cylinder clean and dry, test it after installation, and check that the door opens fully without rubbing the top or a sliding lever. Re-check the bolts after the first few trail runs, since rough roads and flexing tops can loosen fasteners over time.
- Keep the key in a safe place
- Route wiring away from pedals and the steering column
- Check local rules before mounting a CB radio or speakers
Specifications
| Brand | Tuffy |
|---|---|
| Part number | 142-01 |
| UPC | 70000411332 |
| Product type | Overhead security console |
| Material | Steel, 16-gauge |
| Finish | Black powder coat, textured |
| Lock | Double bitted 10 tumbler lock with built-in weather seals |
| Compartments | One, with a swing-away door |
| Speaker cutout | 4 speaker grille cutout, holds a 5 1/4 speaker |
| Models | 2-door and 4-door |
| Installation | Bolts in, no drilling |
| Fit type | Direct fit |
Vehicle fitment
The console is a direct fit for 2-door and 4-door models that use a factory hardtop or soft top, including Jeep factory tops.
Confirm your vehicle’s year, make, model and trim before ordering. Check that the console clears your top and roll bar before installing.
Installation notes
Bolt the console in following the steps for your setup, and check that it does not interfere with the top, the sliding levers or the roll bar. If you install a stereo or CB radio, disconnect the battery first and use correct wiring and fusing.
Keep the key in a safe place, test the lock and door before use, and re-check the bolts after the first miles of driving. Check local regulations before mounting a CB radio or speakers.
What’s included
- Overhead security console with a lockable compartment
- Bolt-in stereo mounting bracket
Not included: the stereo, CB radio, speaker or other electronic device to be mounted.














