Overview
The T-Rex Grilles Upper Class Mesh Grille Insert in black, part number 51467, is a two-piece steel mesh insert for Dodge Ram trucks. It fits the 2006–2008 Dodge Ram 1500, 2500 and 3500 in the Laramie, SLT and SXT trims noted below.
The title and short description note that this insert requires cutting the factory cross bar. The fit is therefore not a plain bolt-in, so read the installation notes before starting and check the opening against the insert.
Key features
- Two-piece steel mesh style
- Black powder-coat finish
- Upper Class mesh line from T-Rex Grilles
- Fits 2006–2008 Ram 1500, 2500 and 3500 trims
- Requires cutting the factory cross bar
- Part number 51467 and UPC 70000477535
Planning the cross bar cut
Cutting a cross bar is a permanent change, so treat it as a planned job rather than a quick swap. Mark the cut line on the factory piece after test fitting the insert, and confirm that the cut will not weaken a mounting point or the area around the radiator. If you are unsure where the bar supports the grille, take time to trace it before any metal is removed.
Steel cutting tools produce heat and sharp burrs, so deburr cut edges and check them for clearance against the insert. A grinder with a cutoff wheel or a fine-tooth hacksaw works for most steel bars. After installation, check the mounting points on the first few drives, and inspect the powder coat near the cut for chips that could start rust.
- Test fit before marking any cut
- Deburr and touch up cut edges to limit rust
- Recheck mounting points after the first drives
Specifications
| Brand | T-Rex Grilles |
|---|---|
| Part number | 51467 |
| UPC | 70000477535 |
| Material | Steel |
| Finish | Black powder-coat |
| Style | Mesh |
| Piece count | 2 pieces |
| Fit requirement | Cut the factory cross bar |
Vehicle fitment
It fits the 2006–2008 Dodge Ram 1500 (Laramie, SLT, SXT), 2500 (Laramie, SLT, SXT) and 3500 (Laramie, SLT). The 3500 fit does not include SXT. Other Ram years and other Dodge models are not covered.
Trims outside those named are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This insert requires cutting the factory cross bar, so plan for a modification rather than a simple bolt-in. Check the insert against the opening before any cutting begins, and use cutting tools suited to steel. Wear eye protection while cutting.
What’s included
Check the package contents for fasteners and cutting tools before starting the modification.









