Overview
The Smittybilt 97380-50 is a wired replacement remote for Gen 1 X2O winches. Smittybilt sells it as a direct replacement unit for a remote that has been damaged, dropped or run over.
The remote works with all Gen 1 Smittybilt X2O winches rated 8, 10, 12 and 15,000 lb. Check the winch’s model and rating before ordering, since the remote must match the control system.
Key features
- Wired remote control
- Direct replacement unit
- Works with Gen 1 X2O 8, 10, 12 and 15,000 lb winches
Remote care and replacement
A winch remote lives in a hard environment. It gets dropped on rock, splashed with mud, and pulled on by the cord when the winch is in use. Keep the remote coiled and out of the way during a pull, and never let it hang where a moving cable or hook can catch it.
Look after the connector as well as the remote itself. Keep the pins clean and dry, and use a small amount of dielectric grease if the connector is exposed to water. Corrosion on the pins is a common cause of intermittent operation, so check the connector before assuming the remote itself has failed.
Replace the remote when buttons stick, when the winch responds only some of the time, or when the cord jacket is cut or pinched. Test the controls with the winch unloaded before a recovery, so a fault is found in the driveway rather than on the trail.
- Keep the cord clear of moving cable and hooks
- Clean and dry the connector pins
- Test controls with the winch unloaded
- Replace for sticking buttons or cord damage
Specifications
| Brand | Smittybilt |
|---|---|
| Part number | 97380-50 |
| Product type | Wired replacement winch remote control |
| Compatible winches | Gen 1 X2O, 8, 10, 12 and 15,000 lb models |
| Connection type | Wired |
| UPC | 631410107104 |
Vehicle fitment
It is matched to Smittybilt winch models, not to a vehicle. Confirm your Gen 1 X2O model before ordering.
What’s included
One wired replacement remote is sold per unit. The winch itself is not included.












