Overview
The Smittybilt Lower Door Hinge Bracket (part 7407) is a pair of stainless steel lower brackets for the door hinge setup. The brackets cover the lower hinge points, and they are sold as a pair so both doors on one side can be matched.
The brackets are a direct fit door hinge part for the lower hinge point, sold as a pair.
Key features
- Stainless steel construction
- Sold as a pair of brackets
- Lower hinge position
- Direct fit door hinge part
Lower hinge loads and wear
The lower hinge on a door carries most of the door’s weight, so it is the point where sag shows up first. A bracket that sits square and tight keeps the door from dropping at the latch side and rubbing the body. Before mounting, clean the bracket seats and the body mount surfaces. Any grit trapped between them can throw the alignment off once the door is closed.
Brackets are usually replaced along with the upper hinge set, since a new lower bracket against a worn upper hinge still leaves the door out of line. Look over the old lower hinge for cracked welds, loose pins and wear on the pivot. Stainless brackets are easy to wipe clean, but the pivot points still need a little grease so they swing smoothly through their full range.
- Clean the bracket and body mounting surfaces
- Inspect the old lower hinge for cracks and wear
- Replace upper hinges together when they show wear
- Grease pivot points after mounting
Specifications
| Brand | Smittybilt |
|---|---|
| Part number | 7407 |
| UPC | 631410065312 |
| Material | Stainless steel |
| Quantity | Pair of brackets |
| Fitment | Direct fit |
Vehicle fitment
Confirm fit for your Jeep’s year, model and trim before ordering, and check the lower door hinge points before mounting the brackets.
Installation notes
Match each bracket to its lower hinge point, and check the door swing after mounting. The brackets do not include the upper hinges, so plan the full setup before you start.
What’s included
A pair of stainless steel lower door hinge brackets.














