Overview
The Rugged Ridge 11116.07 is a fully adjustable hood catch kit supplied as a pair, built for the 2007 to 2018 Jeep Wrangler JK in two-door and four-door models. Rugged Ridge positions it as a direct replacement for factory hood catches, and the kit is non-locking. It suits owners who want a secure hood on a JK without a locking latch.
The finish is silver aluminum or stainless steel. Mounting is bolt-on at the factory mounting points, and the hood bracket is not included, so plan to handle the bracket separately.
Key features
- Fully adjustable catches for a precise hood fit
- Direct replacement for worn factory hood catches
- Bolt-on mounting at the factory mounting points
- Non-locking catch type
- Supplied as a pair for two-door and four-door Wrangler JK models
Adjusting for a square close
A fully adjustable catch lets you set the hood height and the pressure it needs to close cleanly. Start by checking that the hood sits level and evenly spaced against the fenders, then adjust one catch at a time. Small turns make a noticeable difference, so test the close after each change. A hood that closes with too little pressure can rattle, while one set too tight can strain the latch.
Factory mounting points are the right place to bolt the new catches, and the hinge should be inspected first because worn hinges change the hood’s position. Check the existing bracket for bends or cracks before the new catches go on. Replace parts that show wear at the same time, since a fresh catch on a worn bracket will not hold the hood as well as intended. Recheck the fit after the first few drives.
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 11116.07 |
| UPC | 804314241513 |
| Finish | Silver aluminum or stainless steel (both listed) |
| Adjustment | Fully adjustable |
| Catch type | Non-locking |
| Fit type | Direct fit |
| Quantity | Pair |
| Door configuration | 2 or 4 door |
Vehicle fitment
It fits the 2007 to 2018 Jeep Wrangler (JK), including the 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X trims, plus the Unlimited versions of those trims.
Confirm your vehicle’s year, model and trim before ordering. The Wrangler TJ, LJ, YJ and JL, plus the Cherokee and Gladiator, are not among the covered models.
Installation notes
Rugged Ridge says installation takes only basic hand tools. Because the hood bracket is not included, inspect the existing bracket for wear before fitting the new catches, then adjust the catches until the hood closes evenly.
What’s included
A pair of fully adjustable hood catches under part number 11116.07.
Not included: the hood bracket.









