Overview
Part 43130 is the Rhino-Rack Pioneer 48-inch Roof Rack Roller from Rhino-Rack USA. The roller mounts at the back of a Platform or Elevation tray, reaching almost across the whole tray width to help with loading ladders, sheets of timber and other long loads.
New trays can take this roller, and older trays can be retro-fitted. Pioneer Trays are excluded, so confirm your tray model first.
Key features
- Mounts at the rear of a Platform or Elevation tray
- Roller reaches almost the full tray width
- Helps load ladders, sheets of timber and other long items
- Retro-fit option for older trays
Choosing a long-load setup
A roller at the back of a tray lets you slide ladders and sheets of timber without lifting them over the edge. The main benefit is smoother loading and less strain on both the load and the tray surface.
When choosing a setup, consider how the load will sit on the roller and whether you need support at the front of the tray as well. Check the fixings and the tray frame before fitting, and inspect them again after the first few loaded trips. Worn bearings, loose bolts or flattened surfaces are signs the roller should be serviced or replaced.
- Match the roller to your tray type
- Use tie-down points for long, heavy items
- Inspect fixings after early loaded trips
Specifications
| Brand | Rhino-Rack USA |
|---|---|
| Part number | 43130 |
| Size | 48-inch roller |
| Tray type | Platform or Elevation |
| Not suitable for | Pioneer Trays |
Vehicle fitment
No vehicle years or models are named for this roller. It is a tray accessory tied to Platform and Elevation tray designs, so the tray type matters more than the vehicle make.
Older trays need a retro-fit suitability check before fitting, while new trays can be fitted directly. Confirm which applies to your tray before you order.
Installation notes
Check older trays for retro-fit suitability before buying.
What’s included
Compare the parts supplied with your installation steps before you start fitting the roller.










