Overview
The Putco Boss Lockers Side Bed Rail, part number 49862, is a 2 1/2 inch stainless steel side rail for the truck bed of 2009–2010 Dodge Ram 1500 and 2011–2018 Ram 1500 trucks. It mounts through the bed’s stake pockets without drilling, and it is an oversized version of the Boss Locker side rail.
The rail is made for a 5.7 inch bed and has a solid die cast body with a NeveRust stainless steel finish. The design gives the truck a Boss Locker look and adds an anchor point for cargo, with a rated tie down strength of 500 lb.
Key features
- No-drill installation through the stake pockets
- Solid die cast construction
- Rated for 500 lb. tie down strength
- 2 1/2 inch NeveRust stainless steel rail
- The rail is oversized, larger than traditional locker side rails.
- It installs in minutes.
- The rail carries a lifetime warranty.
Stake pocket mounting basics
Rails that mount through stake pockets depend on the pocket condition. Before fitting, clean out the pockets and check that the bed sides are straight and free of bent metal. A pocket filled with dirt or rust can keep a rail from seating square.
Secure cargo on a rail with straps run through the rail’s opening, not hooked loosely over the top. Pull on the rail after installing it and again after the first few drives, and re-tighten any fasteners that have backed off. Keep weight below the rated tie down strength, and spread it across tie points.
Stainless and die cast parts handle weather well, but road salt and grit can still dull the finish. Rinse the rail after wet or salty trips and touch up any scratches that reach bare metal. If a stake pocket cracks or a rail shows movement, stop using it until it is repaired.
- Clean stake pockets before mounting
- Recheck the rail after the first few drives
- Rinse salt and grit off the finish
Specifications
| Brand | Putco |
|---|---|
| Part number | 49862 |
| UPC | 10536498622 |
| Rail | 2 1/2 inch NeveRust stainless steel |
| Construction | Solid die cast |
| Bed size | 5.7 inch |
| Tie down strength | 500 lb. |
| Installation | No drill, through stake pockets |
| Warranty | Lifetime |
Vehicle fitment
It fits 2009–2010 Dodge Ram 1500 (Laramie, SLT, ST, Sport, TRX, TRX4) and 2011–2018 Ram 1500 (Big Horn, Express, Laramie, Laramie Limited, Laramie Longhorn, Limited, Lone Star, Outdoorsman, Rebel, SLT, ST, Special Service, Sport, Tradesman) trucks.
Ram 2500 and 3500 trucks and Ram 1500 model years outside these ranges are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The rail mounts through the existing stake pockets, so no drilling is needed. It installs in minutes. Confirm the package contents against your installation before starting.
What’s included
The rail is the main item in the package. Lay out the parts and check them against your installation before starting.









