Overview
The Power Tank BKT-2275 is a bracket that holds a 72 cu. in. N2 or HPA (high pressure air) bottle. It is used with the N2 Jet Pak, the N2 Lovell T-Case Jet Pak and the N2 Shock Filler Kit.
The bracket has an aluminum frame and a 1 inch wide stainless steel strap with a locking latch, built for the rough use of competition off-road vehicles. Rubber trim holds the bottle secure while protecting the paint and aluminum. It is a direct fit with Power Tank roll bar clamps.
Key features
- Holds a 72 cu. in. N2 or HPA bottle
- Aluminum frame
- 1 inch wide stainless steel strap with locking latch
- Rubber trim protects the bottle and paint
- Direct fit with Power Tank roll bar clamps
Mounting a bottle safely
A bottle bracket is only as secure as the clamps and the mounting point on the roll bar. Before mounting, make sure the bracket sits level and that it does not pinch or rub against wiring, hoses or the bottle valve. A bottle that shifts under load can damage fittings, so the strap and latch should be checked before each trip.
Bottles used for air-powered tools and inflation systems are pressurized, so keep the valve protected and the bottle away from heat sources. Confirm the fill and regulator setup matches the system the bottle serves, whether that is a jet pak or a shock filler kit.
Inspect the strap, latch and rubber trim periodically. Replace worn trim before it lets the aluminum or paint rub, and tighten clamps after the first few trail runs.
- Check strap and latch before each trip
- Keep the valve clear of the bracket edges
- Inspect rubber trim for wear
Specifications
| Brand | Power Tank |
|---|---|
| Part number | BKT-2275 |
| UPC | 70000469590 |
| Bottle size | 72 cu. in. |
| Bottle type | N2 or HPA (high pressure air) |
| Frame | Aluminum |
| Strap | 1 inch wide stainless steel with locking latch |
| Trim | Rubber |
Vehicle fitment
No vehicle years, makes or models are named for this bracket. It is a bottle mount that works with roll bar clamps, so the fit depends on the clamp and bottle combination in your setup.
Confirm the bottle and clamp combination before installing the bracket.
Installation notes
Confirm that the 72 cu. in. bottle sits correctly in the bracket and that the strap locks before the bracket is mounted to the roll bar clamps.
What’s included
One Power Tank Super Bracket for a 72 cu. in. bottle, part number BKT-2275.
Not included: the bottle and roll bar clamps.








