Overview
The Poison Spyder recovery strap (part number 57-63-515) is a 30 foot by 3 inch nylon strap for recovering a stuck vehicle. It is made of industrial strength nylon webbing rated at 24,250 lb minimum breaking strength. The strap is dyed black and sewn with red thread, and it is labeled with the Poison Spyder logo.
Nylon stretches under load, which is why this type of strap is used for recovery. It stretches up to 20 percent when in use. That stretch lets the recovery vehicle build momentum before the strap goes tight, rather than jerking the stuck vehicle and the strap at once. Rigid materials tend to jerk when they go tight, which can damage both vehicles and bystanders. Keep the strap in the kit with a couple of 3/4 inch recovery shackles.
Key features
- 30 foot length and 3 inch wide nylon webbing
- 24,250 lb minimum breaking strength rating
- Stretches up to 20 percent to absorb shock loads
- Reinforced, stitched loop ends
- Red loop end protectors and red protective sleeves
- Thermofixed and treated for long wear
Using a recovery strap safely
A recovery strap works best when the pull is steady and the stuck vehicle is not pulled sideways. Keep both vehicles in line with the strap, and keep people out of the zone between them and out of the path of the strap if it fails. Use a rated shackle at each connection, and make sure the anchor points on both vehicles are solid before any pull starts.
Storage matters as much as use. Keep the strap dry, clean and out of direct sunlight, and coil it loosely so it does not kink. Grit and salt work into the weave and wear the fibers from inside, so rinse and dry the strap after muddy trips.
- Keep bystanders clear of the strap line
- Inspect for cuts, abrasion and worn stitching
- Use gentle, steady pulls rather than jerks
- Retire any strap that shows heat damage
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 57-63-515 |
| UPC | 614901737592 |
| Type | Recovery strap, nylon |
| Width | 3 inch |
| Length | 30 feet |
| Color | Black, with red stitching and loop protectors |
| Load rating | 24,250 lb working load limit and minimum breaking strength |
| Stretch | Up to 20 percent |
Vehicle fitment
This is a universal recovery strap. It is not tied to a specific vehicle, and it can be used with any 4×4 that has a suitable recovery point.
The load rating applies to the strap itself. Match the strap to the weight of the vehicles it will recover and check that the recovery points can take the load.
Installation notes
No installation is needed. Inspect the strap before each use, since cuts and abrasion reduce its strength.
What’s included
One recovery strap, 30 feet by 3 inches, with stitched loop ends and protective sleeves.
Not included: recovery shackles. The maker suggests keeping a couple of its 3/4 inch recovery shackles in the kit with the strap.








