Overview
The K&N 63-1136 AirCharger air intake system is built to replace the factory air filter and air intake housing on some Polaris Ranger RZR models. It pairs an oversized cone-shaped K&N high-flow filter with an enclosed filter housing and an aluminum intake tube that carries air to the throttle body.
The intake smooths and straightens airflow so the engine can draw in a larger volume of air than the factory assembly allows. More air means more usable power and acceleration across the RPM range. Confirm your exact Ranger RZR model and year before fitting this intake.
Key features
- Oversized cone-shaped K&N high-flow air filter
- Enclosed filter housing that protects the filter from the elements
- Free-flowing aluminum intake tube feeding the throttle body
- Designed to reduce intake restriction compared with the factory filter assembly
- Filter stated to last up to 100,000 miles before service, depending on driving conditions
- Designed to add usable power over the factory intake
Ranger RZR intake considerations
An intake swap on a side-by-side is mostly about breathing. The engine pulls air through the filter, the housing and the tube before it reaches the throttle body, so each part adds or removes restriction. A larger filter area usually helps, but only if the housing and tube seal correctly and route air without sharp bends.
Off-road riding puts dust, mud and water into the air path. An enclosed housing protects the filter from splash and debris, which keeps service intervals more predictable. After riding in dusty or wet conditions, pull the filter and check the seal before the next ride.
- Check the aluminum tube for cracks after rough trails
- Tighten clamps after the first few rides
- Keep the throttle body clean when the intake is removed
- Confirm the filter seat before closing the housing
Specifications
| Brand | K&N |
|---|---|
| Part number | 63-1136 |
| UPC | 24844364791 |
| System | AirCharger air intake system |
| Filter housing | Enclosed |
| Intake tube material | Aluminum |
| Filter service interval | Up to 100,000 miles, depending on driving conditions |
Vehicle fitment
This intake is designed to replace the factory intake on some Polaris Ranger RZR models.
Confirm fit for your Ranger RZR’s year, model and trim before ordering and before fitting the kit.
Installation notes
K&N describes installation as usually taking 90 minutes or less. The tools called for are a ratchet set, a few wrenches and a flat blade screwdriver. Expect to remove the factory air filter housing and fit the aluminum tube between the new filter and the throttle body.
What’s included
Use of this intake is prohibited in California and in any state enforcing California emission standards.






















