Overview
The Omix-Ada 19715.03 is a front windshield wiper motor with a four wire flat plug. It fits the 1983 Jeep CJ5, the 1983–1986 Jeep CJ7 and the 1983–1985 Jeep Scrambler and measures 7-3/8 inch long by 2-1/4 inch diameter.
Key features
- Front position wiper motor
- Four wire flat plug connector
- Measures 7-3/8 inch long by 2-1/4 inch diameter
- Built to original specifications, with a limited five year warranty.
Wiper motor replacement tips
A wiper motor is a gearbox with an electric drive, and its output shaft carries the arm through a set angle. Wear in the gears shows as slower sweeps, a louder hum or a park position that drifts. Heat from long use and water entering the connector are common causes of failure in older CJ and Scrambler motors.
Before fitting a new motor, check the mounting bracket and the linkage connection. Make sure the motor is in park when the arm is attached so the blade rests at the bottom of the glass. A quick test with the linkage disconnected helps confirm the motor turns freely before it is refitted.
- Check the mounting bracket for cracks
- Inspect the connector for corrosion
- Set the motor to park before fitting the arm
- Test the motor before refitting the linkage
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 19715.03 |
| UPC | 804314038366 |
| Position | Front |
| Connector | 4 wire flat plug |
| Length | 7-3/8 inch |
| Diameter | 2-1/4 inch |
Vehicle fitment
It fits the 1983 Jeep CJ5 (Base, Laredo, Limited and Renegade), the 1983–1986 Jeep CJ7 (Base, Laredo, Limited and Renegade) and the 1983–1985 Jeep Scrambler (Base, Laredo, Renegade, SL and SR).
Wrangler and other Jeep models outside these CJ and Scrambler years are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The motor uses a four wire flat plug, so check that your existing wiper harness connector matches before fitting it.









