Overview
The Omix-ADA 12023.22 is a tailgate hinge for the 1976–1983 Jeep CJ5 and the 1979 Jeep CJ7 in the Base trim. Two hinges are required, and each is primed for rust prevention.
The hinge is a direct OE replacement built to original specifications and comes with a limited five year warranty. It arrives with a primer finish, so plan any topcoat before installing.
Key features
- Primed for rust prevention
- Two hinges are required.
- Direct OE replacement built to original specifications
- It fits the 1976–1983 Jeep CJ5 and the 1979 Jeep CJ7 Base.
- Part number 12023.22 with UPC 804314039363
Matching hinges and alignment
Tailgate hinges on older CJ bodies work as a pair, so both should be replaced together to keep the gate square. A single new hinge beside a worn one can leave one side sitting lower, which puts uneven strain on the gate and the remaining hinge. Confirm that both hinges are the same design before you begin.
Primer protects bare steel while the hinge waits to be used, but it is not a finished coat. Sand any rough spots lightly and apply the topcoat you plan to use for the tailgate. Fit the hinges loosely first, then tighten them once the gate lines up with the body.
- Replace both hinges together
- Sand rough primer spots before painting
- Support the gate while adjusting
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 12023.22 |
| UPC | 804314039363 |
| Finish | Primed for rust prevention |
| Quantity required | 2 |
| Warranty | A limited five year warranty applies. |
Vehicle fitment
It fits the 1976–1983 Jeep CJ5 in Base, Golden Eagle, Laredo, Limited and Renegade trims, and the 1979 Jeep CJ7 in Base trim only.
Other CJ7 model years are not covered, and Wrangler and Cherokee models are not covered either. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Two hinges are required, so confirm both are being replaced before starting. Support the tailgate while the old hinges come off.














