Overview
The Omix-Ada Inside Release Door Handle in black, part 11812.19, is a replacement inside door handle for the driver side, front or rear, on a Jeep Wrangler JK. It works with manual locks only.
It replaces a broken or damaged inside door handle with a direct factory-fit part.
Key features
- Driver side front or rear position
- Black finish
- For manual locks only
- Two-door and four-door Wrangler JK models
Checking your lock type
The inside release handle is the part you pull from inside the cabin to open the door, and it works through a rod to the latch. Cracked plastic, a loose pivot or a handle that does not return fully are common reasons for replacing it. Before ordering, confirm the lock type, since this handle is built for manual locks only.
Power lock vehicles use a different arrangement, so a manual-lock handle will not match their linkage. Look at the door panel and the lock switch to see how your door operates before you start disassembly. Note the rod clip and the screw locations so the new handle goes back in the same way.
Once installed, test the handle from inside several times and check that the latch releases fully. Lubricate the pivot lightly with general-purpose grease so the action stays smooth.
- Confirm the door has manual locks
- Photograph the rod connection before removal
- Test the latch from inside after installation
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 11812.19 |
| UPC | 804314289652 |
| Position | Front left |
| Side | Driver |
| Color | Black |
| Lock type | Manual locks only |
| Door type | Hard door |
Vehicle fitment
It fits 2007–2016 Jeep Wrangler (JK) models, both two-door and four-door. Confirm fit for your vehicle’s year, model and trim before ordering.
The list stops at 2016, so 2017–2018 Wrangler JK models are not included, and the Wrangler JL is not covered. The passenger side is not covered by this part either. Confirm your vehicle’s year, model and trim before ordering.












