Overview
The Omix-ADA 17233.01 is a headlight dimmer switch made for 1946 to 1971 CJ Jeep models. It is a direct OE replacement built to original specifications, so it takes the place of a factory-style switch rather than adding new function.
Shoppers searching for a CJ headlight switch will find the years and model line stated here, but no model variant or wiring diagram is given, so confirm the match against your vehicle before installing.
Key features
- Direct OE replacement design
- Built to original specifications by Omix-ADA
- Fits 1946 to 1971 CJ models
- Covered by a limited five year warranty from Omix-ADA
Dimmer switch on older CJs
On older Jeeps, the dimmer switch sends low and high beam selection to the headlamp circuit, and it is often mounted near the floor or dash where heat and dust build up. Contacts in these switches wear from repeated use, so high beam may fade or fail to hold position before the switch stops working entirely.
When replacing a switch on an older vehicle, keep the original wiring colors in mind and label the connectors before removal. Many owners replace the headlight switch alongside corroded ground points, since a poor ground can mimic a failed dimmer. Check the fuse and relay circuit as well so the new switch is not blamed for a wiring fault. Keep the old switch until the new one is tested so you can compare the connector pinout.
- Label each connector before unplugging
- Clean ground points to bare metal
- Test low and high beam on the bench first
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 17233.01 |
| UPC | 804314014490 |
| Type | Headlight dimmer switch |
| Warranty | Limited five year warranty from Omix-ADA |
Vehicle fitment
It fits 1946 to 1971 CJ Jeep models. Confirm fit against your vehicle’s year and model before buying.
Vehicles built after 1971 are outside the stated years. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One headlight dimmer switch. No mounting hardware or wiring harness is mentioned.









