Overview
The Omix-ADA Gas Cap 17726.02 is a non locking gas cap and a direct fit replacement. It is a direct OE replacement Jeep part built to the original specifications.
The gas cap carries a limited five year warranty. Confirm fit for your vehicle’s year, model and trim before ordering.
Key features
- Non locking gas cap
- Direct OE replacement design
- Built to original specifications
- Limited five year warranty
Fuel cap seal and venting
A fuel cap does more than close the filler neck. Its seal keeps fuel vapor inside the tank and keeps water and dirt out, and many modern fuel systems rely on the cap to hold pressure correctly. A cap that does not seal can leak vapor, cause odors and, on some vehicles, set a warning light.
When replacing a cap, check the gasket, the threads and the fit against the filler neck. The cap should tighten until it clicks or reaches its stop, and it should sit flat without wobble. Old caps often crack at the seal or wear at the threads, so replacing a worn one is usually simpler than trying to clean up a leak.
- Check the gasket for cracks or flattening
- Look for stripped or worn threads
- Confirm the cap tightens fully before driving
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 17726.02 |
| Product type | Gas cap |
| Locking | Non locking |
| Warranty | Limited five year |
| Fitment type | Direct fit |
Vehicle fitment
This is a direct OE replacement for Jeep vehicles. Compare the cap with your existing one before ordering.
Compare the cap’s fit with your fuel filler neck before ordering. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Make sure the cap seals fully on the filler neck before driving.
Check that the cap tightens fully to its stop, and replace it if the seal or threads look worn.
What’s included
One non locking gas cap.
Not included: a key or lock set, since this cap is non locking.









