Overview
The Omix-Ada front fuel supply line, part number OAI17732.30, is a replacement line for the 1994–1998 Jeep Grand Cherokee (ZJ) with the 4.0L 6 cylinder engine. It runs from the frame rail mounted fuel supply line to the fuel rail and replaces OE 52127633. It is designed to meet or exceed OE standards for fit.
Key features
- Front position fuel supply line
- Runs from the frame rail mounted supply line to the fuel rail
- Replaces OE 52127633
- Designed to meet or exceed OE standards for fit
Fuel line fittings and leaks
A front supply line runs from the frame rail to the fuel rail, so it passes through a fairly tight area where heat, road debris and flex all act on the fittings. Before connecting it, check each end for debris, clean the seating surfaces and make sure the line sits free of any tension.
Fuel fittings should be snug and free of kinks. Recheck the connection points after the engine has run and cooled, looking for seepage or a wet film near the joints. A small leak caught early is much easier to address than one left until the fuel rail is saturated.
Keep sparks, open flame and hot surfaces away from the area while working on the fuel system, and relieve pressure before disconnecting any fitting.
- Clean and inspect each fitting before connecting
- Keep the line free of kinks and tension
- Check joints for seepage after the engine cools
- Relieve pressure before disconnecting fittings
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | OAI17732.30 |
| Position | Front |
| Engine | 4.0L 6 cylinder |
| Replaces OE | 52127633 |
| Fitment type | Direct Fit |
Vehicle fitment
It fits the 1994–1998 Jeep Cherokee (XJ) (Classic, Country, Limited, SE, Sport), 1994–1998 Jeep Grand Cherokee (ZJ) (5.9 Limited, Laredo, Limited, Orvis, SE, TSi) and 1994–1995 Jeep Wrangler (YJ) (Renegade, Rio Grande, S, SE, Sahara).
The 4.0L engine applies to the Grand Cherokee ZJ models. Confirm the engine on the XJ and YJ entries before fitting, and check your year, model and trim.
Installation notes
Check the fuel line fittings for leaks after installation and before the engine is run.
What’s included
Clamps and fittings are separate needs, so gather them before connecting the line.












