Overview
The Omix-Ada factory-style replacement front right fender flare, part number OAI11609.22, is a passenger side front flare for the 2007–2018 Jeep Wrangler JK, in both 2-door and 4-door models. It is a direct replacement for the original factory flare and has a textured black original equipment design.
Each flare is made of UV treated thermoplastic, designed to keep the material from turning gray and chalky. Each replacement flare is designed to fit the factory mounting holes, though some models may need hole relocation.
Key features
- Direct replacement for original factory fender flares
- Textured black original equipment design
- UV treated thermoplastic construction
- Designed to fit factory mounting holes
- Designed to be painted.
- Passenger side front position
Factory fit and hole alignment
A replacement flare is only useful if it lines up with the factory mounting holes and sits flush with the fender. Before final tightening, hold the flare in place, check the gap along the top edge and confirm the bolt holes line up. If you must enlarge or move a hole, deburr the edge and protect the paint underneath.
Front flares on a JK are exposed to road spray and trail debris. Clean the mounting surface, use corrosion-resistant fasteners, and check the flare after each off-road outing. If the flare is loose or rattles, look for worn clips or bent tabs before tightening further.
- Test-fit before final tightening
- Deburr any new hole edges
- Use corrosion-resistant fasteners
- Inspect after off-road trips
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | OAI11609.22 |
| Position | Front right (passenger side) |
| Style | Factory-style replacement |
| Material | UV treated thermoplastic |
| Finish | Textured black, paintable |
| Model exclusions | Sahara models are not covered |
Vehicle fitment
The manufacturer fitment list covers the 2007–2018 Jeep Wrangler (JK), including 2-door models with 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport and X trims, and Unlimited 4-door models with the same trim names.
It fits the 2007–2018 Jeep Wrangler (JK) in 2-door models with 70th Anniversary, 75th Anniversary, Rubicon, Sport and X trims, and Unlimited 4-door models with the same trim names. Sahara models are not covered by this part. The Wrangler JL and the earlier LJ and TJ are not covered either.
Installation notes
Some models may require hole relocation to line up with the factory mounting holes. Test-fit the front flare against the factory holes before fully tightening the hardware.
What’s included
It is one front right replacement flare.
Not included: Mounting hardware is not included, so check whether your factory hardware will be reused.










