Overview
The Omix-ADA 12035.48 is a black factory-style rear bumper cap for the passenger side of the 1984–1996 Jeep Cherokee XJ, sitting in the rear right position.
It is built to the XJ’s original specifications and covers the Cherokee years and trims covered here.
Key features
- Black finish
- Rear passenger-side position
- Factory-style design
- Direct fit for the 1984–1996 Cherokee XJ
Rear cap fitting and care
A rear bumper cap covers the corner of the rear bumper, where it helps finish the bumper’s outline. Before fitting, compare the cap with the existing corner, checking mount points, clip locations and the outer edge. Clean the mounting surface so the cap sits flat and does not rub against the bumper.
Clips and tabs can wear with age, so replace any that are cracked or bent rather than forcing the cap into place. Check for stress marks near the mounts after rough use, since impacts often show up at the edges first. Tighten fasteners evenly to keep the cap in line. Mild soap and water keep the black finish looking even over time, and a quick fit check after the first few drives helps.
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 12035.48 |
| UPC | 804314049928 |
| Location | Rear |
| Position | Rear right (passenger side) |
| Color | Black |
| Bumper type | Factory style |
| Fitment type | Direct fit |
Vehicle fitment
The cap covers the 1984–1996 Jeep Cherokee XJ in the Base, Chief, Classic, Country, Laredo, Limited, Pioneer, SE and Sport trims.
It does not fit the Wrangler, Comanche or Grand Cherokee, or the driver-side rear position. Make sure your year, model and trim match before you order.
What’s included
One black factory-style rear passenger-side bumper cap.









