Overview
The Omix-ADA 12302.04 is a cowl seal for the 1987–1995 Jeep Wrangler (YJ) in Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport trims.
It is a direct OE replacement Jeep part built to the original specifications. Adhesive is not included, and it carries a limited five year warranty.
Key features
- Cowl seal for the 1987–1995 Jeep Wrangler (YJ)
- Direct OE replacement built to original specifications
- Limited five year warranty
- Adhesive is not included
Sealing the cowl on a YJ
On a Wrangler YJ, the cowl seal sits where the hood meets the body and keeps water from running down into the engine bay and cabin. Original seals can harden and split after years of sun and heat, which lets water and dust in and makes the hood rattle when closed.
Before fitting, clean the cowl and remove old adhesive, rubber residue and dirt. Let the surface dry completely, then dry-fit the seal to check the run and ends. Keep the seal from stretching during installation, and check that the hood latch and alignment are sound, since a poorly aligned hood can crush a new seal.
Other parts often replaced at the same time include the hood bumpers and the windshield seal, since they share the same contact area and wear together.
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 12302.04 |
| UPC | 804314056032 |
| Type | Cowl seal |
| Adhesive | Not included |
| Warranty | Limited five year warranty |
Vehicle fitment
It fits the 1987–1995 Jeep Wrangler (YJ) in Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport trims.
The list does not include Wrangler TJ, JK or JL models, or the CJ models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because adhesive is not included, plan for a separate adhesive before fitting the seal to the cowl.
What’s included
The cowl seal.
Not included: adhesive.









