Overview
The MagnaFlow MF Series Cat-Back Exhaust System, part number M/F19470, is a stainless steel cat-back exhaust with a single side exit and 3 inch tubing. It fits the 2019 Chevrolet Silverado 1500, Silverado 1500 LD, GMC Sierra 1500 and Sierra 1500 Limited.
A cat-back system replaces the piping from the catalytic converter back to the tailpipe, so the factory headers and converter stay in place. MagnaFlow engineers this model with straight-through flow, which the brand says supports horsepower and torque gains while keeping exhaust efficiency. Its High Temp Satin Black coating gives the tubing a dark finish and added surface protection. Made in the USA, the system is tested against SAE J1169 standards to balance interior and exterior noise levels.
Key features
- Straight-through flow design that MagnaFlow describes as unrestricted for horsepower and torque
- Single side exit with 3 inch tubing
- High Temp Satin Black coating for protection and a dark finish
- Stainless steel construction
- Tip included
- Made in the USA
- Tested against SAE J1169 standards for balanced interior and exterior noise
Installation and first drive
The cat-back layout leaves the factory headers and catalytic converter in place, so the work starts at the converter outlet and runs to the tailpipe. Good prep includes a clean workspace, penetrating oil on old clamps and a plan for supporting the exhaust while the new hangers are set. Because stainless steel tubing is handled more carefully than mild steel, avoid bending the pipes out of shape during fitting.
After the first drive, check that the pipe clears the frame and the rear crossmember, and listen for buzzing that may point to a loose clamp. Heat from the tubing can stain nearby surfaces, so keep plastic trim and wiring away from the outlet. The satin black finish should be cleaned gently to protect the surface. Recheck the hangers after the first few weeks of driving, and make sure the tip sits straight.
Specifications
| Brand | MagnaFlow Exhaust |
|---|---|
| Part number | M/F19470 |
| Exit location/type | Single side |
| Material | Stainless steel |
| System type | Cat-back |
| Tubing size | 3 inches |
| Tip | Included |
| Finish | High Temp Satin Black coating |
| Testing | SAE J1169 standards |
| Fitment type | Direct fit |
| Origin | Made in the USA |
Vehicle fitment
It fits the 2019 Chevrolet Silverado 1500 in Custom, Custom Trail Boss, High Country, LT, LT Trail Boss, LTZ, RST, SSV and WT trims, the 2019 Silverado 1500 LD in LT and WT trims, the 2019 GMC Sierra 1500 in AT4, Base, Denali, Elevation, SLE and SLT trims, and the 2019 GMC Sierra 1500 Limited in Base and SLE trims.
Other model years and Silverado or Sierra 2500 and 3500 models are not in this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The exhaust tip is included with this kit, so a separate tip is not needed for the single side exit.









