Overview
This Key Parts replacement front floor brace is built for the passenger side of the front floor area. Its high gauge steel body carries an OEM electro-deposit primer (EDP) finish.
It is intended for rust and collision repair on the passenger side of the front floor, and its shape follows the original part. Check the side and UPC 70000700343 first.
Key features
- Passenger-side replacement front floor brace
- High gauge steel construction
- OEM electro-deposit primer (EDP) finish
- Front position, direct fit.
Finishing the repair area
Once a passenger-side front brace is welded or bolted in, the finish work protects the joint. Clean any heat-affected metal, apply weld-through primer where the seam is exposed, and coat the flange edges so moisture does not sit in the lap. A brace that sits flush with a sealed seam tends to stay drier than one left with open gaps.
Check the coating around the new brace before covering it. Underbody coating over bare steel can trap moisture if applied too early, so let primer cure fully. Keep the front footwell area clear of debris during finish work, and inspect the seams again after the first wet weather.
- Clean heat-affected metal
- Seal the lap joints
- Let primer cure before coating
- Inspect seams after the first wet weather
Specifications
| Brand | Key Parts |
|---|---|
| UPC | 70000700343 |
| Part type | Replacement front floor brace |
| Position | Front, passenger side |
| Material | High gauge steel |
| Finish | OEM electro-deposit primer (EDP) |
Vehicle fitment
Key Parts identifies it as a direct fit for the front spot. Match the passenger-side position to your vehicle’s manufacturer specifications before ordering.
A driver-side brace does not replace this part. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Gather fasteners and sealer before starting the install.












