Overview
The Jeep caliper adapter mounting bolt, part number 6513551AA, is an authentic OEM Mopar replacement part. It replaces part number 68003276AA and is universal fit, so the replaced number is the main identifier to check.
Because it is a numbered OEM replacement, the replaced part number is the main identifier to check against your current bolt.
Key features
- Authentic OEM Mopar replacement part
- Replaces part number 68003276AA
- Universal fit
- Jeep part number 6513551AA
Torque and thread checks
A caliper adapter bolt holds the adapter to the knuckle or carrier, so it carries braking loads every time the brakes are used. Thread condition, length and seating surface matter as much as the part number. A bolt that is too short or has damaged threads can loosen under load, so inspect the old bolt and the mounting hole before reinstalling.
Clean the threads and mounting hole, and use the bolt in the position it was removed from. Apply thread treatment only if the procedure calls for it, and confirm the torque value for your vehicle before tightening. Replace any bolt that shows stretching, rust pitting or a deformed head rather than reusing it.
- Inspect the old bolt for stretch or pitting
- Clean the threads and the mounting hole
- Confirm the torque value for your vehicle
Specifications
| Brand | Jeep |
|---|---|
| Part number | 6513551AA |
| Replaces | 68003276AA |
| Manufacturer | Mopar (OEM) |
| Fitment type | Universal fit. |
Vehicle fitment
No vehicle, year or model is named for this bolt. Match the replaced number, 68003276AA, against the bolt you are removing before buying.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Caliper adapter bolts are fasteners that should be tightened to the torque value for your vehicle, so use the specification from the service information for your model.
What’s included
A single mounting bolt. The caliper adapter itself is not included.










