Overview
The Omix-ADA grille push pin fastener secures the grille to the support on 2007-2017 Jeep Wrangler JK and JKU models. It replaces OE 6503598.
The pin is sold individually and six are required. Omix-ADA describes its parts as meeting or exceeding OE standards.
Key features
- Secures the grille to the support
- Replaces OE 6503598
- Sold individually, six required
- Direct fit for 2007-2017 Wrangler JK and JKU models.
Grille fastener care
Grille push pins hold the grille to its support, and they sit in a spot exposed to engine heat, road spray and repeated vibration. Over time the plastic can become brittle, the heads can crack and the legs can lose their hold. When one pin fails, the grille can shift slightly or rattle, and the extra movement puts load on the remaining pins. Checking all of them at the same time is a sensible habit whenever one needs replacing.
Removal is easiest with a trim tool and a steady hand. Pull the pin straight out rather than twisting it, and check the mounting hole for debris before seating the new one. Press each pin until it locks, then wiggle the grille gently to confirm it is secure. Avoid overtightening anything in this area, since the plastic supports break more easily than the pins themselves.
- Inspect all pins when one fails
- Use a trim tool to avoid damaging the grille
- Seat each pin fully until it locks
Specifications
| Brand | Omix-Ada |
|---|---|
| OE number replaced | 6503598 |
| UPC | 804314293765 |
| Type | Grille push pin fastener |
| Application | Grille to support |
| Quantity required | 6, sold individually |
| Fitment type | Direct Fit |
Vehicle fitment
It fits 2007-2017 Jeep Wrangler JK and JKU models. Wrangler JL models from 2018 on fall outside these years.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Six pins are needed, so plan for a full set of six before starting. Each pin is sold individually.
What’s included
The grille push pin fastener, sold individually. Six are required for the grille.












