Overview
The Fabtech FTS94043 is a black polyurethane sway bar clamp system that keeps the sway bar centered on the frame through the full range of front suspension travel. It is designed for a 1-3/16 inch sway bar and uses a split-collar design.
The clamps fit the 2004–2006 Jeep Wrangler LJ, including Unlimited and Unlimited Rubicon, and the 1997–2006 Jeep Wrangler TJ in several trims.
Key features
- Split-collar design for easier installation
- Keeps the sway bar centered on the frame through front suspension travel
- Designed for a 1-3/16 inch sway bar
- Black polyurethane construction
- Supplied as a pair
Before you install
Sway bar clamps hold the bar to the frame, so their fit affects steering feel and body roll on both road and trail. Polyurethane clamps resist compression better than rubber but are firmer, so expect a slightly different ride over sharp bumps. A split collar eases fitting around an installed bar, though the clamp still needs to seat evenly so the bar can rotate freely.
Look at the frame mounts and bar ends before fitting new clamps. Rust, cracked welds or bent brackets need attention first, since clamps cannot correct a misaligned bar. Apply grease to the contact surfaces where the design allows, and check that the bar turns freely by hand once the hardware is tight.
- Measure the bar before fitting
- Clean rust from frame mounts
- Recheck hardware after the first drives
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FTS94043 |
| UPC | 674866018662 |
| Color | Black |
| Material | Polyurethane |
| Sway bar diameter | 1-3/16 inch |
| Quantity | Pair |
| Mounting position | Front suspension |
Vehicle fitment
The clamp system fits the 2004–2006 Jeep Wrangler LJ (Unlimited, Unlimited Rubicon) and the 1997–2006 Jeep Wrangler TJ (65th Anniversary Edition, Rubicon, SE, Sahara, Sport, X).
The 2007–2018 Wrangler JK is not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The split-collar design is meant to simplify installation, but check that the bar measures 1-3/16 inch before fitting the clamps. Lift and support the vehicle safely before working near the front suspension.
What’s included
A pair of black polyurethane clamps. Check the package contents against your installation before starting.









