Overview
The Crown Automotive 52006495 is a rear left stabilizer bar cushion, also called a sway bar bushing, with a .95 inch inner diameter. It fits the 1990–1993 Jeep Cherokee (XJ), the 1990–1992 Jeep Comanche, and the 1994–2002 Dodge Ram 2500 and Ram 3500.
A sway bar cushion sits where the stabilizer bar meets its mount and keeps the bar centered as the axle moves. This cushion is a direct-fit part for the rear left position, so it replaces a worn or cracked cushion on that side.
Key features
- Rear left position, as shown in Crown’s position listing
- It is a direct fit for the vehicles covered below.
- .95 inch inner diameter
- Crown part number 52006495 with UPC 848399013818
Signs the cushion is worn
Rear sway bar cushions sit where the bar meets the frame or axle mount, so they take constant rotational load. On older trucks and compact SUVs, the rubber can dry out and crack, which lets the bar move and create a clunk when the rear suspension cycles. Inspect both rear cushions at the same time, since uneven wear makes the bar sit off center and changes handling.
When fitting a replacement, clean the bar and mount surfaces and compare the new cushion with the old one before installing. Rear brackets and end links are often inspected alongside the cushion, and worn links can cause similar noise. Tighten all fasteners evenly, using the torque figures in your vehicle’s service manual.
- Clunks or rattles over rear bumps
- Cracked or hardened rubber at the mount
- Bar sitting off center in its mount
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 52006495 |
| UPC | 848399013818 |
| Position | Rear Left |
| Fit type | Direct Fit |
| Inner diameter | .95 inch |
Vehicle fitment
It fits 1990–1993 Jeep Cherokee (XJ), 1990–1992 Jeep Comanche, 1994–2002 Dodge Ram 2500 and 1994–2002 Dodge Ram 3500.
The list does not include other Cherokee XJ years, Wrangler models or Grand Cherokee. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One rear left stabilizer bar cushion. Check the package contents against your installation before starting.









