Overview
The Crown Automotive 55022102 is a black factory-style rear bumper end for the passenger side of the 1987–1990 Jeep Cherokee XJ. It sits in the rear right position and is a direct fit for the trims shown below.
Fits the 1987–1990 Cherokee XJ only. Confirm fit for your vehicle’s year, model and trim before ordering.
Key features
- Black finish
- Rear passenger-side position
- Factory-style design
- Direct fit for the 1987–1990 Cherokee XJ
Replacing a rear bumper end
A rear bumper end takes corner impacts and anchors the bumper to the body. When it cracks, sags or loses its mounting tabs, the bumper can shift out of line and the corner of the vehicle is less protected. Replacement is usually a matter of removing the bolts that hold the old end, aligning the new piece and tightening it to the bumper support.
Before fitting, compare the old end’s position and mounting holes with the new part, and clean the mounting surfaces so the end sits flush. Check the bumper cover and nearby trim for cracks that an impact might have caused, since those are often replaced in the same job.
- Cracks or split plastic near the mounting points
- Sagging or uneven gap with the body
- Broken or pulled-loose mounting tabs
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 55022102 |
| Location | Rear |
| Position | Rear right (passenger side) |
| Color | Black |
| Bumper type | Factory style |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1987–1990 Jeep Cherokee XJ in the Base, Chief, Laredo, Limited, Pioneer and Sport trims.
It fits 1987–1990 Cherokee XJ models in the rear passenger-side position. Confirm fit for your vehicle’s year, model and trim before ordering, especially for years outside 1987–1990.
What’s included
One black factory-style rear passenger-side bumper end.









