Overview
The Borla BOR140405 is a stainless steel cat-back exhaust system for the 2010-2014 Toyota FJ Cruiser Base. It is a cat-back system, so the pipes behind the catalytic converter are replaced while the front exhaust stays installed. It uses 2.5-inch tubing and a dual split rear exit.
The system is made from stainless steel. The FJ Cruiser Base is the only vehicle covered by this part.
Key features
- Cat-back system type
- Stainless steel construction
- Dual split rear exit
- 2.5-inch tubing
- Tip included
Living with stainless steel exhaust
Stainless steel resists rust far better than mild steel, which matters on a vehicle that sees salt, mud and water crossings. Heat discoloration on the pipes is normal and does not signal a fault. Over time the welds and bends should be checked for cracks, especially near the rear muffler where the system sees the most movement.
Off-road use puts the rear section at risk from rocks and stumps. A dent that pinches the pipe can reduce flow and change the sound, so look at the outlet after each trip over rough ground. Keep the hangers snug and make sure the pipes do not contact the spare tire carrier or the frame.
- Check welds and bends for hairline cracks
- Look for dents that pinch the pipe
- Keep hangers snug after rough trips
- Confirm the tip is secure at the outlet
Specifications
| Brand | Borla |
|---|---|
| Part number | BOR140405 |
| System type | Cat-back |
| Material | Stainless steel |
| Exit location/type | Dual split rear |
| Tubing size | 2.5 inches |
| Tip included | Yes |
| Fitment | Direct fit |
Vehicle fitment
Manufacturer fitment lists 2010-2014 Toyota FJ Cruiser (Base) for this kit, and no other models or years.
Fit covers the 2010-2014 FJ Cruiser Base only. Confirm fit for your vehicle’s year, model and trim before ordering.
What’s included
The tip is included. Check the package contents against your installation before fitting.










