Overview
The ARB awning bracket, model 813402, is a zinc plated and powder coated mounting bracket for attaching awnings to roof bars on vehicles used off road or under extreme conditions. Its welded gussets add strength where the awning loads the bracket. It is universal fit and mounts to roof bars rather than to a specific vehicle model.
The bracket is 50 mm wide, which lets it fit over Thule SquareBar and Rhino Heavy Duty bars when mounted inverted. Used upright, it mounts with T-bolts or channel nuts on Thule ProfessionalBar, WingBar and AeroBar, or Rhino Heavy Duty bars. It is designed to mount either upright or inverted, so one bracket suits more than one bar design.
Key features
- Welded gussets for additional strength when awnings are mounted to roof bars
- Zinc plated and powder coated for corrosion resistance
- Designed to mount either upright or inverted
- 50 mm wide, fits over Thule SquareBar and Rhino Heavy Duty bars in the inverted position
- Pre-drilled to accept 8mm bolts
- Three slotted 6mm holes for mounting the awning
Mounting an awning safely
An awning puts sideways and upward loads on roof bars, so the bracket and its fixings do most of the work. Before mounting, check that the roof bars are secure to the rack and that nothing shifts when you push on the bracket. Re-check the bolts after the first drive and again after rough tracks, since vibration loosens fixings over time.
Awnings also catch wind, so take the awning down when conditions get strong. Storing the awning dry and clean helps prevent mould on the fabric and corrosion on the bracket. Keep the gusset area free of mud and grit so the welds and surfaces can be inspected easily.
- Inspect welds and gussets for cracks
- Tighten bolts after the first drive
- Remove the awning in strong wind
Specifications
| Brand | ARB 4×4 Accessories |
|---|---|
| Part number | 813402 |
| UPC | 9332018036285 |
| Width | 50 mm |
| Bolt holes | Pre-drilled to accept 8mm bolts |
| Awning holes | Three slotted 6mm holes |
| Finish | Zinc plated and powder coated |
| Mounting | Upright or inverted |
| Hardware | Not included |
| Fitment | Universal Fit |
Vehicle fitment
It is universal fit and not tied to a vehicle model. Fit depends on the roof bar it mounts to, such as Thule SquareBar, Thule ProfessionalBar, Thule WingBar, Thule AeroBar, or Rhino Heavy Duty bars.
Confirm your roof bar matches one of these designs and has suitable T-bolt or channel nut options before ordering.
Installation notes
Mount the bracket to the roof bar with at least two bolts, but preferably three, for maximum strength. Always use the outer bolt hole between the gussets, otherwise the gusset is not effective. Hardware is not included, and ARB recommends the T-bolts and channel nuts supplied by the roof bar manufacturer.
What’s included
The bracket comes without hardware. Mounting bolts, T-bolts and channel nuts are not included.
Not included: Mounting hardware, the awning and the roof bars.








