Overview
The MSD 8210 Automatic Coil Selector is an ignition performance module from MSD for running dual MSD ignitions. It is built for setups that use two ignitions and two coils, and it cannot be used with MSD 7, 8 or 10 Series ignition systems.
Dual ignition wiring basics
Running two ignitions means each system needs its own clean trigger, power and ground. A coil selector manages how the coils are used across both ignitions, so the wiring must be labeled and correct before the engine is started. Mistakes in the trigger or ground path can cause misfires or erratic timing that are hard to trace later.
Plan the harness layout before mounting anything. Keep the low-voltage ignition wires separated from high-voltage coil leads, and secure every connector so vibration cannot loosen it. Ground points should be clean and bare metal. Once the setup runs, recheck connections and wire routing after the first few drives.
- Label every trigger and coil lead before connecting
- Keep low-voltage wires separate from coil leads
- Use clean, bare metal ground points
- Recheck connectors after the first few drives
Specifications
| Brand | MSD |
|---|---|
| Part number | 8210 |
| UPC | 85132082100 |
| Ignition setup | Requires 2 ignitions and 2 coils |
| Compatibility | Cannot be used with MSD 7, 8 or 10 Series ignition |
Vehicle fitment
It is an ignition module for dual MSD ignition setups, so it is matched to your ignition and coil layout rather than to a vehicle. Check your ignition and coil count before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the selector needs two ignitions and two coils, it belongs only in a dual ignition layout. Work with a qualified installer and disconnect the battery before changing any ignition wiring.









