Overview
The Aries Offroad Pro Series Grille Guard, part ARSP1050, is a bolt-on steel grille guard that holds an LED light bar inside its center flange instead of mounting it on the outside. It fits the 2007–2018 Jeep Wrangler JK and the 2018 Wrangler JL Unlimited Moab 4-door.
The light bar sits on an articulating channel bracket that adjusts up or down, left or right, and forward or back. The bracket accepts light bars from 20 inches down to 6 inches. The center flange is enclosed in 12 gauge steel, and a high gloss mesh front lets light through while keeping the bar out of sight.
Key features
- Center flange houses the LED light bar
- Articulating channel bracket for up, down, left, right, forward and back adjustment
- Accepts light bars from 6 inch to 20 inch
- 12 gauge steel enclosure with a high gloss mesh front
- Optional brushed stainless and black carbon open face plates
- Solid one-piece bolt-on design with no cutting or drilling
Choosing light bar size
A light bar housed in the center flange is protected from brush and trail debris, and the lens sits behind a mesh front. Choosing the right bar length matters: pick a bar that fits the channel range and leaves room for the bracket to articulate. Measure the bar before ordering and check the mounting points against the bracket.
Articulating brackets let you aim the light up, down, left, right, forward and back, which helps with trail lighting and road beams. Set the angle with the truck parked, then recheck after rough driving, since vibration can shift the bracket’s position over time. Tighten the adjustment locks until the bar holds its angle firmly.
Light wiring should be planned before the bar goes in. Route the harness away from moving parts and the radiator fan, and use a fused switch so the bar can be shut off when not in use. Clean the mesh front regularly, since mud reduces light output.
- Measure the light bar before ordering
- Set the aim with the truck parked
- Plan wire routing before the install
Specifications
| Brand | Aries Offroad |
|---|---|
| Part number | ARSP1050 |
| Application | Jeep Wrangler JK, 2007–2018; Jeep Wrangler JL Unlimited Moab, 2018 |
| Construction | 1/4 inch plate and 1-1/2 inch OD cold rolled carbon steel |
| Enclosure | 12 gauge steel |
| Finish | Textured black powder coat |
| Light bar range | 6 inch to 20 inch |
| Weld-on | Not weld-on |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct fit for the 2007–2018 Jeep Wrangler (JK) in 2-door and 4-door models, and for the 2018 Jeep Wrangler (JL) Unlimited Moab 4-door.
The JL entry is limited to the 2018 Unlimited Moab, so other 2018–2022 Wrangler JL entries are not covered by this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
It is a solid one-piece bolt-on design with no cutting or drilling. Check the light bar size against the channel range before mounting.
What’s included
Check package contents against the bracket and mount before installing. Optional brushed stainless and black carbon open face plates are available separately.

















