Overview
The T-Rex Grilles 25567 is a polished billet aluminum bumper grille insert that mounts in the bumper air dam opening, between the factory fog lamps, on 1999–2004 Ford Super Duty F-250 and F-350 trucks and the 2000–2004 Ford Excursion. Its horizontal bar layout gives the opening a machined, all-metal look.
T-Rex describes its billet grilles as bolt-on designs that need fewer tools and no cutting of the bumper, and that is the main installation point the company stresses. The insert is cut from solid T-5 or T-6 billet aluminum instead of extruded stock, finished with a glossy powder-coat, and then polished in three stages and cleaned at the company’s Southern California plant.
Key features
- Billet aluminum insert cut from T-5 or T-6 stock rather than extruded aluminum
- Glossy powder-coat finish over polished aluminum
- Three-stage polishing and cleaning at T-Rex’s Southern California facility
- Bolt-on design that T-Rex says needs fewer tools and no cutting
- Horizontal bar pattern that mounts in the bumper air dam opening between OE fog lamps
- Direct fit listing for the vehicles below
Air dam and fog lamp fit
The air dam opening sits low on the front of the truck, where it takes the most road spray and debris. Any insert in that position should be checked for clearance with the fog lamps, the lower valance and any splash shields, since those parts can shift slightly when the bumper is handled.
Working around fog lamp wiring calls for care. Disconnect the battery before unplugging connectors, label them if the harness is unfamiliar, and keep the wiring away from sharp edges of the insert. A seated connector and a square insert usually go together in less time than a rushed install.
Heavy-duty trucks carry more front-end weight and often add winches or bumpers, so check that the insert does not interfere with any accessory mounts you plan to keep.
- Check fog lamp clearance before final tightening
- Label connectors before unplugging them
- Confirm accessory mounts will still fit
Specifications
| Brand | T-Rex Grilles |
|---|---|
| Part number | 25567 |
| UPC | 609579003575 |
| Material | Billet aluminum, T-5 or T-6 grade |
| Finish | Polished aluminum with glossy powder-coat |
| Orientation | Horizontal |
| Mounting location | Bumper air dam opening, between OE fog lamps |
| Installation type | Bolt-on insert |
| Fitment listing | Direct Fit |
Vehicle fitment
It is a direct fit for these vehicles:
- 2000–2004 Ford Excursion (Eddie Bauer, Limited, XLS, XLT)
- 1999–2004 Ford F-250 Super Duty (Harley-Davidson Edition, King Ranch, Lariat, XL, XLT)
- 1999–2004 Ford F-350 Super Duty (Harley-Davidson Edition, King Ranch, Lariat, XL, XLT)
Ford Super Duty model years after 2004 and other Ford models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the insert is a bolt-on piece, plan on fewer tools than a cut-in grille would need, since T-Rex states no cutting is required. Check that the fog lamps are fully seated and that the insert sits square in the opening before you tighten anything. Disconnect the battery before working near fog lamp wiring.
What’s included
Check the package contents, including mounting hardware, against your installation before starting.









