Overview
The Rigid Industries SR-Series light cover, part number 105993, is a polycarbonate cover that adds lens protection to a Rigid LED light. It is made to keep the lens protected and to give the light a unique look.
The cover can also serve where states require covers on accessory lights. Since it is a light accessory, the sizing and model match matter more than any vehicle.
Key features
- Made from durable polycarbonate plastic
- Snap-on fit for simple removal and replacement
- Extra layer of protection for the lens
- Gives the light a unique look
Installing and removing covers
Removing a snap-on cover is a quick task, but it works best when done with care. Hold the cover at the edges and pull evenly so the snap points release without bending. Pressing on the center can strain the lens area, so use the rim instead. Keep the old cover in a safe place if you may reuse it, so it stays clean and undamaged.
Refitting goes the same way: align the cover with the light face, then press each side until every snap seats. A cover that sits crooked may trap moisture or dust along one edge. Check the seal after installation and again after the first few drives on uneven roads.
- Work on a clean, dry light face
- Press the rim evenly around the edge
- Recheck seating after the first drives
Specifications
| Brand | Rigid Industries |
|---|---|
| Part number | 105993 |
| UPC | 849774025983 |
| Material | Polycarbonate plastic |
Vehicle fitment
This cover is not vehicle-specific and no make, model or year is named. Check your Rigid LED light model before ordering.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Only the cover is included with this part number. The Rigid LED light it protects is not part of this order.
Not included: the Rigid LED light the cover protects.









