Overview
The Recon 264156Y is a heavy-duty three piece wiring kit used to install Recon cab lights on a vehicle that did not have factory installed cab lights. It is intended for GMC and Chevy 07-13 (New Body Style) vehicles.
The kit also carries Universal Fit, so confirm the year, model and trim of your vehicle before installing.
Key features
- Installs Recon cab lights on vehicles without factory cab lights
- Heavy-duty construction
- Three piece set
- Named for GMC and Chevy 07-13 (New Body Style) vehicles
Planning the wire route
Cab light wiring is a small circuit, but it runs through a cabin that has moving parts, heat and vibration. Plan the route before cutting anything. Keep wires away from exhaust components, sharp body edges and pedals, and secure them with clips so they do not sag or rub.
Protection at the fuse is important. Place the fuse close to the power source so a short anywhere along the run is interrupted quickly. A relay lets a switch control the light at low current, which reduces wear on the switch contacts. Ground connections should be clean, bare metal, tightened firmly.
Related parts are often replaced during the same job. Old switches, corroded grommets and brittle loom can all cause trouble after a new light is added. Reinspect the circuit after the first few drives and check that the lights work with the ignition in each position.
- Route wires away from heat and pedals
- Fuse the circuit close to the battery
- Clean and tighten all ground points
Specifications
| Brand | Recon |
|---|---|
| Part number | 264156Y |
| UPC | 810614012746 |
| Kit type | Cab light wiring kit |
| Quantity | 3-piece set |
| Duty | Heavy-duty |
| Vehicles named | GMC and Chevy 07-13 (New Body Style) |
| Fitment | Universal Fit |
Vehicle fitment
It is intended for GMC and Chevy 07-13 (New Body Style) vehicles and also carries Universal Fit. Confirm your year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Plan the wire route before installing, and fuse the circuit as part of the lighting install. Disconnect the battery before running any wiring.
What’s included
The set contains three pieces. Check the individual wires and connectors against your installation before starting.
Not included: the Recon cab lights themselves, since the kit is used to install them.









