Overview
The Fab Fours JK1051-1 is a set of rear grab handles in black, built from 1/2 inch thick steel. Confirm fit for your vehicle’s year, model and trim before ordering.
The handles need no drilling to install, and they carry a 16 gauge steel logo skin for customization. Fab Fours says they are always made in the USA.
Key features
- Rear position grab handles
- Black finish
- 1/2 inch thick steel construction
- 16 gauge steel logo skin for customization
- No drilling required
Using rear handles safely
Rear grab handles help passengers and cargo handlers steady themselves when they climb in or out of the back of a vehicle. Placement at the rear corners is important, since the handle must clear the tailgate, spare tire carrier and any rear bumper accessories. Check the swing and clearance before relying on the handle for support.
Black finished steel holds up to daily use, but scuffs and grit wear the paint away over time. Clean the handle after muddy trips and look for cracks at the welds or base. A handle that moves when pulled should be tightened or replaced, since loose hardware fails under load and can leave the grip unsafe.
- Check clearance with the tailgate open
- Tighten fasteners after rough trips
- Look for cracks near the base
- Clean grit from the finish regularly
Specifications
| Brand | Fab Fours |
|---|---|
| Part number | JK1051-1 |
| UPC | 5810113971 |
| Position | Rear |
| Color | Black |
| Construction | 1/2 inch thick steel |
| Logo skin | 16 gauge steel |
| Installation | No drilling required |
Vehicle fitment
Check the rear mounting position against your vehicle before fitting.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Confirm the included hardware and handle count before starting.












