Overview
The Hi-Lift VERS-LK is a locking knob for Hi-Lift Jack mounts, with a 1/2 inch bolt and part number VERS-LK. It replaces the existing knob or wing nut on a mounting accessory. Once tightened, the knob is locked with the provided key, which secures the jack in the mount.
The VERS-LK fits adjustable tube mounts, 4XRAC and Loc-Rac mounts. It can also secure the Unique Winch-Clamp-Spreader attachment, which is supplied only with X-TREME jacks. The hood-mount version is the HM-LK, so match the knob to your mount type before ordering.
The VERS-LK is a locking knob that Hi-Lift describes as a safe lock for the jack. Once locked, the knob spins freely and stays put on the mount, which protects the jack from being pulled out of its mounting position.
Key features
- Replaces the existing knob or wing nut on compatible mounts
- Locked with the provided key once tightened
- Locked knob spins freely and stays on the mount
- Works with adjustable tube mounts, 4XRAC and Loc-Rac
- Also secures the winch-clamp-spreader attachment for X-TREME jacks
- Built with a 1/2 inch bolt
Locking a jack mount safely
A jack that is not held firmly in its mount can shift or fall out on rough ground, so the lock is part of the recovery setup rather than an extra. Before every trip, check that the knob is fully tightened and that the lock engages. Keep the key with the jack or somewhere you can reach quickly, since a jack you cannot release is slow to use in an emergency.
Vibration on trails can loosen knobs over time, so look over the mount after rough runs. Check the bolt threads for damage and replace worn parts rather than forcing a loose mount to hold. Avoid overtightening by hand until the knob bites hard, and never use the lock as a substitute for a properly seated jack. Clean the threads of dirt before tightening so the fit stays consistent.
Specifications
| Brand | Hi-Lift Jack |
|---|---|
| Part number | VERS-LK |
| UPC | 52767008522 |
| Bolt size | 1/2 inch |
| Compatible mounts | Adjustable tube mount, 4XRAC, Loc-Rac |
| Also secures | Winch-clamp-spreader attachment (X-TREME jacks) |
| Lock | Key provided |
Vehicle fitment
This knob fits adjustable tube, 4XRAC and Loc-Rac mounts, and fit depends on the jack mount on your vehicle. Hood mounts use the HM-LK instead.
This knob does not cover hood jack mounts, which use the HM-LK. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Remove the existing knob or wing nut and fit the VERS-LK in its place. Tighten it, then lock it with the provided key. Keep the key with your jack so it is available when you need to lock or release the mount.
What’s included
Hi-Lift VERS-LK locking knob and the provided key.
Not included: the Hi-Lift jack and the mount it locks into.














