Overview
The Grant Steering Wheels Grant Installation Kit (part number 4198) is the standard kit for mounting Classic, Challenger or Signature series Grant steering wheels. It is also used for the Vehicle Security System.
It fits Chevrolet G10, G20 and G30 vans and GMC G15, G1500, G25, G2500, G35 and G3500 vans and trucks, from 1975 to 1982, including the Beauville, Chevy Van, Sportvan, Rally and Vandura trims.
Key features
- Standard installation and horn kit for Grant steering wheels
- Die cast hub
- Grade 5 mounting hardware
- Matte black trim pieces
- Complete step-by-step instructions included
Horn circuit and column fit
The horn on a Grant wheel completes its circuit through a contact ring or plate beneath the hub, so the connection depends on the wheel sitting flat and centered on the column. Once the hub is tightened, the wheel should turn without binding, and the horn should sound only when the pad is pressed. Intermittent horn operation after an install usually points to a loose contact or a poor ground rather than the switch itself.
Good preparation saves rework. Lay out the hub, trim and hardware before starting, and keep the battery disconnected until the horn wiring is confirmed. Older G-series columns often have worn bushings or stiff tilt mechanisms, so inspect those while the steering shaft is exposed. Recheck all fasteners after the first few drives.
- Confirm the horn contact turns freely before final assembly
- Check wiring at the column for chafing
- Recheck hub fasteners after the first few drives
Specifications
| Brand | Grant Steering Wheels |
|---|---|
| Part number | 4198 |
| Type | Install kit |
| Hub | Die cast |
| Hardware | Grade 5 mounting hardware |
| Trim | Matte black |
| Compatible wheels | Classic, Challenger and Signature series |
Vehicle fitment
It fits Chevrolet G10, G20 and G30 and GMC G15, G1500, G25, G2500, G35 and G3500 models from 1975 to 1982.
Trucks and vans outside that list, including later model years, are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This is a standard installation and horn kit, so the horn wiring is part of the job. Disconnect the battery before working on the steering column, and follow the step-by-step instructions in the kit in order.
What’s included
A die cast hub, grade 5 mounting hardware, matte black trim and complete step-by-step instructions.
Not included: the steering wheel itself, which this kit is used to install.









