Overview
The Crown Automotive J0989940 is a front windshield wiper switch with 4 prongs, for 1973–1975 Jeep CJ5 and CJ6 models. The switch controls the wipers from the dash and is located and positioned at the front.
It is a direct fit replacement for the CJ5 and CJ6 vehicles covered here.
Key features
- 4-prong wiper switch
- Front location and position
- Direct fit for the CJ5 and CJ6 models covered here.
Dash switch wear and checks
A dash wiper switch sends a signal through its contacts to the motor, so worn internal contacts show up as a switch that sticks, feels loose, or works in only some positions. Before replacing it, check the wiring plug for corrosion or heat damage, since a bad plug can mimic a failed switch.
Switches on older CJ models are often mounted near the heater controls and can collect dust or moisture from the cowl. Keep the mounting area dry and check the switch housing for cracks. When removing the switch, photograph the prong wiring or label each wire so the new switch can be connected the same way.
If the switch is replaced, test each speed setting and the park function before reassembling the dash.
- Inspect the housing for cracks
- Photograph the wiring before removal
- Test each speed setting
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J0989940 |
| UPC | 848399056754 |
| Connector | 4 prong |
| Location | Front |
| Position | Front |
Vehicle fitment
Listed fitment: 1973–1975 Jeep CJ5 (Base, Renegade) and 1973–1975 Jeep CJ6 (Base).
Other CJ years, the CJ7 and Scrambler are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Match the 4-prong layout to your original switch before installing. Disconnect the battery before you work on the switch wiring.
What’s included
Check the quantity and any wiring or hardware you need against your original switch before installing.









