Overview
The Corbeau E2050NS is a driver side seat bracket for the 2004–2006 Jeep Wrangler LJ Unlimited and Unlimited Rubicon. It mounts a Corbeau slider to the factory seat bracket and is one of the adapter brackets required for Corbeau seats. CJ and YJ brackets replace the original brackets, while TJ adapters bolt onto them.
Key features
- Driver side seat bracket
- Mounts a Corbeau slider to the factory seat bracket
- Cannot flip forward for rear access
- Corbeau adapter brackets are required with all Corbeau seats
Seat bracket fitment basics
A seat bracket carries the full load of the seat, the occupant and crash forces, so the mounting points matter as much as the seat itself. Before fitting an adapter, look at the factory bracket for cracked welds, bent tabs, rust, and loose or stripped fasteners. Any of these means the bracket should be repaired or replaced before a new slider goes on, since an adapter cannot correct a weak anchor point.
Adapters also change how the seat sits. Check that the slider travels freely and locks fully in every position, and that the seat does not rub the door panel, console or seat belt buckle. Once the seat is in place, recheck all fasteners after the first few drives, since vibration on a Wrangler can loosen hardware that was snug at installation.
- Check welds and mounting tabs for cracks before fitting
- Test the slider lock in each position
- Confirm the seat belt buckle clears the seat
- Recheck fasteners after the first few drives
Specifications
| Brand | Corbeau |
|---|---|
| Part number | E2050NS |
| UPC | 70000429273 |
| Adapter type | Bracket |
| Side | Driver |
| Mounting | Slider mounts to the factory seat bracket |
| Forward flip for rear access | Not capable |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2004–2006 Jeep Wrangler (LJ), including Unlimited and Unlimited Rubicon.
Earlier Wrangler TJ, YJ and CJ models do not fit this bracket, which uses a different design for those vehicles. Check your year, model and trim against this fit before ordering.
Installation notes
This bracket attaches a slider to the factory seat bracket, so inspect the factory bracket for damage before fitting the new slider.
What’s included
Check the included hardware against your installation before starting.
Not included: the seat itself. Baja SS seats need a special adapter, part 22002, sold separately.









