Overview
The Bubba Rope 16′ Tree Hugger, part number 176016OR, is a 16 foot tree strap for winching. It wraps around a tree so your winch cable can pull your four-wheel-drive vehicle out of a difficult situation without girdling the bark or scarring the trunk. Bubba Rope designed it for off-road trips where you want to leave your surroundings green and un-scarred.
The strap is made from 3 inch wide 100% polyester webbing with a tough Cordura covering over the synthetic webbing. Reduced eyelets make it easy to attach a joining shackle. It is universal fit, so it is not built for one particular vehicle or model, and it suits anyone who winches in the backcountry and wants a gentler anchor than the winch cable wrapped directly around a trunk.
Key features
- Made from 3 inch wide 100% polyester webbing for a soft wrap around the trunk.
- Tough Cordura covering over the synthetic webbing for added web protection.
- Keeps the winch cable from girdling the bark off the tree.
- Reduced eyelets for easily attaching a joining shackle.
- 16 foot length for wrapping around larger trunks.
- Listed breaking strength of 58000.
Protecting trees on the trail
A tree strap spreads the pull over a wide band of bark, so the anchor point takes the load instead of the trunk being cut by the winch cable. Wrap the strap at a height where the trunk is solid and free of loose bark, and keep the strap clear of sharp rock edges that could cut the webbing under load.
Inspect the webbing and Cordura cover before each trip and after every pull. Dirt and grit work into the fibers and wear them down, so rinse the strap if it gets muddy and let it dry fully before storing. Store it somewhere dry and out of direct sun to slow fading and stiffening of the material.
- Inspect webbing for cuts, abrasion and fraying
- Keep the strap away from sharp rock edges
- Store dry and out of direct sun
Specifications
| Brand | Bubba Rope |
|---|---|
| Part number | 176016OR |
| UPC | 859811003089 |
| Length | 16 feet |
| Width | 3 inches |
| Material | 100% polyester webbing |
| Covering | Tough Cordura covering over the synthetic webbing |
| Eyelets | Reduced eyelets for attaching a joining shackle |
| Breaking strength | 58000 (no unit stated) |
| Fitment | Universal fit |
Vehicle fitment
The Tree Hugger is a universal fit strap for anchoring a winch line to a tree, with no year, model or trim tied to it. Check the 16 foot length and 3 inch width against your recovery setup. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Wrap the Tree Hugger around a solid tree, then attach the winch line to the reduced eyelets with a joining shackle so the cable stays off the bark. Keep bystanders clear of the line while the winch is under load.












