Overview
The Bestop Rear Seat Cover in Black Diamond, part number 29229-35, is a custom-designed vinyl cover for the rear seat of a Jeep Wrangler or CJ. It fits over the factory original seat to shield the upholstery from ultraviolet light, dust, mud and water.
Open-air driving exposes seats to conditions that wear them down over time. This cover can be put on or taken off in about 10 minutes, so owners can protect the rear seat on trail days and remove it when a clean look is needed. The fit is tight, with no shifting or bunching, and the cover does not interfere with any seat functions.
Vehicle fit is set for Jeep Wrangler and CJ rear seats. Confirm your year and trim before buying.
Key features
- Custom designed to fit over the factory original rear seat
- Bungee-cord attachment holds the cover in place
- Installs without tools in about 10 minutes
- Tight fit that does not shift, bunch or block seat functions
- Water resistant vinyl construction
- Black Diamond finish
- Complete with instructions and all the necessary hardware
Trail days and clean-seat days
A rear seat cover is easiest to manage when it goes on for a trail day and comes off when the seat needs a clean look. Keep the cover’s hooks and cords out of the seat belt buckle area so the belt latches freely. Check the belt path after every refit to make sure nothing is pinched under the cover.
Vinyl rear covers are used on open-air vehicles where dust and water collect on the seat base. Water resistance helps keep moisture off the cushion, but it does not seal the seam edges. Dry the seat fully before fitting, since trapped moisture can wear the upholstery underneath faster than the cover protects it.
- Remove the cover before loading gear that could snag the vinyl
- Store the cover flat in a dry place when not in use
- Replace hooks or cords when they no longer hold the cover snug
Specifications
| Brand | Bestop |
|---|---|
| Part number | 29229-35 |
| UPC | 77848074678 |
| Position | Rear |
| Material | Vinyl |
| Color | Black Diamond |
| Fitment type | Direct fit |
| Water resistance | Water resistant |
Vehicle fitment
It is designed for the rear factory seat of Jeep Wrangler and CJ models.
Confirm your vehicle’s year, model and trim before ordering, including whether your rear seat is an earlier or later generation.
Installation notes
The cover installs without tools, with bungee-cord attachment as the fastening method. Because it goes over the factory seat, check that the seat is clean and dry before fitting so the tight fit can be achieved.
What’s included
One rear seat cover in Black Diamond, with attachment hardware and instructions.









